Permanent impairment assessment

Sacroiliac Joint WPI Assessment NSW

Sacroiliac Joint WPI Assessment NSW explains how a NSW workers compensation WPI assessment is usually approached, what medical findings matter and what evidence should be checked before relying on a percentage.

What should be checked before relying on a WPI figure?

Check maximum medical improvement, the body area, objective findings, the NSW Guideline chapter and any NSW modification before relying on a percentage.

Can this page calculate your percentage?

No. WPI depends on an assessor, maximum medical improvement, objective findings and the NSW Guidelines. This page is general information only.

Permanent impairment assessment

How permanent impairment is assessed for Sacroiliac joint injury, dislocation, fracture-dislocation and fixation

Sacroiliac WPI needs separation between sacroiliac pain, lumbar referred pain and a true sacroiliac dislocation or fracture-dislocation. NSW Table 4.3 gives specific rows for sacroiliac displacement and internal fixation or ankylosis. Pain around the SI joint is not, by itself, the same as a ratable SI joint table row.

What injuries can happen to this body part?

  • Sacroiliac sprain or pain syndrome after lifting, twisting, pregnancy-related factors or trauma
  • Sacroiliac dislocation or fracture-dislocation with residual displacement
  • Sacroiliac internal fixation or ankylosis after pelvic ring injury

Symptoms and findings that matter

  • Whether the condition is a true SI joint dislocation/fracture-dislocation or pain without table-level structural change
  • Residual displacement level, including the lower SI displacement row and the more-than-1-cm row, where the dislocation/fracture-dislocation row applies
  • Whether internal fixation or ankylosis is present
  • Whether lumbar spine, hip, pelvic fracture or neurological findings are separate and need their own method
  • Causation and apportionment where degeneration, pregnancy, prior trauma or non-work factors are raised

What investigations are usually relevant?

  • Treating specialist report and final impairment assessment at maximum medical improvement
  • Imaging, pathology, audiology, ophthalmology, respiratory, nerve or functional testing that fits the body system
  • Operative reports, discharge summaries, rehabilitation records and objective clinical measurements where relevant

How WPI is assessed for this body part

  • Sacroiliac WPI needs separation between sacroiliac pain, lumbar referred pain and a true sacroiliac dislocation or fracture-dislocation. NSW Table 4.3 gives specific rows for sacroiliac displacement and internal fixation or ankylosis. Pain around the SI joint is not, by itself, the same as a ratable SI joint table row.
  • Assessment source: NSW Guidelines Chapter 4, Table 4.3 sacroiliac dislocation/fracture-dislocation and internal fixation/ankylosis rows.
  • The assessor should explain maximum medical improvement, the body-system chapter, the method selected, any NSW modification, and why the objective findings fit that method.

How movement affects the assessment

  • SI joint symptoms can affect sitting, walking, stairs and transitions, but NSW Table 4.3 focuses on structural sacroiliac rows rather than general movement loss.
  • Function evidence may still matter for capacity and treatment disputes, even when the WPI row depends on displacement or fixation.

NSW Table 4.3 pelvic fracture rows

Non-displaced healed pelvic fracture0% WPI where the NSW table criteria fit.
Pelvic bones, including sacrum, residual displacement less than 1 cm2% WPI where the NSW table criteria fit.
Pelvic bones, including sacrum, residual displacement 1 to 2 cm5% WPI where the NSW table criteria fit.
Pelvic bones, including sacrum, residual displacement more than 2 cm8% WPI where the NSW table criteria fit.
Pubic symphysis residual displacement less than 1 cm5% WPI where the NSW table criteria fit.
Pubic symphysis residual displacement 1 to 2 cm8% WPI where the NSW table criteria fit.
Pubic symphysis residual displacement more than 2 cm12% WPI where the NSW table criteria fit.
Pubic symphysis internal fixation or ankylosis5% WPI where the NSW table criteria fit.
Sacroiliac dislocation or fracture-dislocation, lower residual displacement row8% WPI where the NSW table criteria fit.
Sacroiliac dislocation or fracture-dislocation, residual displacement more than 1 cm12% WPI where the NSW table criteria fit.
Sacroiliac internal fixation or ankylosis5% WPI where the NSW table criteria fit.
Two out of three pelvic joints internally fixed or ankylosed8% WPI where the NSW table criteria fit.
All three pelvic joints internally fixed or ankylosed10% WPI where the NSW table criteria fit.
Multiple pelvic injuriesCombine values, with the maximum value for pelvic fractures limited to 20% WPI.

Practical WPI examples

  • A sacroiliac dislocation or fracture-dislocation falling within the lower SI displacement row is listed as 8% WPI under NSW Table 4.3; the table separately lists more than 1 cm residual displacement as 12% WPI.
  • Residual displacement of more than 1 cm is listed as 12% WPI under NSW Table 4.3.
  • Sacroiliac internal fixation or ankylosis is listed as 5% WPI under NSW Table 4.3.

Evidence checklist

  • A clear diagnosis and the body area being assessed
  • Records showing the condition has reached maximum medical improvement, if that is the issue
  • Specialist reports, imaging reports and treating notes relied on by the assessor
  • Objective findings on examination, not only symptoms described by the injured person
  • A work and treatment chronology explaining the injury, treatment, surgery and recovery path
  • Any previous injury, degeneration, congenital issue or non-work cause that needs apportionment considered
  • Pelvic CT/X-ray reports, orthopaedic notes, fixation records, rehabilitation notes and clinical material separating SI, lumbar and hip symptoms

What usually does not increase WPI

  • Assuming a scan result automatically gives a WPI percentage
  • Confusing pain, disability or inability to work with permanent impairment
  • Ignoring maximum medical improvement before arranging an assessment
  • Using an AMA5 table without checking whether the NSW Guidelines modify or replace it
  • Double counting the same impairment through two methods when the Guidelines require one method
  • Calling every low-back or buttock pain complaint a sacroiliac table injury
  • Ignoring displacement measurement
  • Counting the same pelvic ring problem twice through overlapping rows

Assessment source

Assessment source: Assessment source: NSW Guidelines Chapter 4, Table 4.3 sacroiliac dislocation/fracture-dislocation and internal fixation/ankylosis rows.

This section is source-backed general information. It is not a WPI assessment and is not legal advice.

Related injury and claim pages

Need a practical claim check?

If an impairment percentage, medical assessment or insurer decision is affecting your NSW injury claim, send the decision or report for a practical review. This is general information only and does not guarantee any result.

Request a free claim check

Assessment scope for Sacroiliac Joint WPI Assessment

The assessment scope for Sacroiliac Joint WPI Assessment should be stated precisely before any percentage is considered. The file should identify whether that label describes the primary diagnosed condition, a symptom of another injury, a regional overview or one component of a broader impairment. Findings from another body area or diagnosis should not be transferred without explanation. The report should connect the stated condition to the correct NSW Guideline chapter, objective findings, treatment history and any permitted combination or apportionment method. This distinction is particularly important where similar page labels cover different clinical questions.

  • Confirm the diagnosis and body area being assessed as Sacroiliac Joint
  • Separate condition-specific findings from overlapping symptoms or injuries in another body area
  • Check that the selected NSW Guideline chapter and method match the condition actually assessed
  • Explain any combination, apportionment or exclusion rather than relying on the page label alone

Start with maximum medical improvement

Permanent impairment should generally be assessed when the condition is stable and unlikely to change substantially in the next year. Treatment, surgery and rehabilitation history may affect whether the timing is appropriate.

Use the NSW Guidelines first

The NSW Guidelines adopt AMA5 in many areas, but NSW modifications prevail. Do not assume an AMA5 table applies without checking the NSW chapter and any public SIRA clarification.

Keep the assessment practical

A useful assessment file separates diagnosis, objective findings, surgery history, work capacity issues, apportionment questions and the body-area method used by the assessor.

Ask about an impairment issue

Documents and records

Injury evidence to organise early

The useful records depend on how the injury happened, when symptoms were recorded and how treatment or work capacity changed.

  • Date, location and short description of the injury event
  • Medical certificates, reports, scans, treatment records or hospital documents
  • Employer, insurer, police, incident or venue records where relevant
  • Photos, witness details, dashcam or other supporting material if available
  • Income, superannuation, work capacity or leave records where relevant
  • Letters, emails, claim numbers and decisions already received

Common questions

Injury evidence questions

Short general answers only. The right next step depends on the facts, dates and documents.

Is WPI the same as being unable to work?

No. WPI is a medical impairment measure. Work capacity, weekly payments, damages, treatment disputes and TPD issues are separate questions, although the evidence may overlap.

Does pain alone create a WPI percentage?

Not by itself. NSW workers compensation excludes AMA5 Chapter 18 on pain. Chronic pain is assessed through the underlying diagnosed condition where the Guidelines permit it.

Can secondary psychological symptoms be added to physical WPI?

In NSW workers compensation, secondary psychiatric or psychological impairment is not assessed as permanent impairment. Primary psychological impairment is assessed separately and is not combined with physical WPI.

Injury pathway enquiry

Not sure which claim type matches the injury?

Start with how the injury happened, what medical records exist and how work or daily activity has changed. The same injury can sit in different pathways.

CallClaim details